The Data Validation Editor in HEC-RTS allows you to validate and edit incoming data in two ways:

  • Graphically – using the graphical editing area (top half of the dialog)
  • Tabularly – using the data table (bottom half of the dialog)

This guide will walk you through both methods.

Editing Data in the Graphical Area

  1. Follow these instructions to open the Data Validation Editor using your preferred method.
  2. Use the zoom tool to focus on the area of concern in the plot.
  3. Select an appropriate editing tool — either the single-point or multi-point editor.
  4. Click directly on the plot to make your edits.
  5. When finished, click Accept or Accept All to apply your changes.

Editing Data in the Tabular Area

  1. Follow these instructions to open the Data Validation Editor using your preferred method.
  2. Use the zoom tool to focus on the area of concern in the plot.
  3. Use the selector tool and click a point in the plot.
  4. The table below will update to show the point selected.
  5. Enter a new value in the Estimate/Entry column for that data point. 
  6. Click Accept to apply your change.

Additional Resources

For detailed information on editing data, refer to the HEC-DSSVue documentation.