HEC-MetVue supports editing of data across Zones. This is performed with the Zonal Adjustment Editor. This editor allows for vertically scaling or setting the values of TIN/Grid points within that zone. The goal may be to correct values within a given region or analyze scenarios with different spatial distribution of values. For example, if a precipitation grid is assumed to poorly estimate data in higher elevations, a high elevation zone may be used to increase those precipitation values.

Adjustments can take the form of Uniform or Normalized adjustments. For Uniform adjustments, the user is setting all cells within that zone to the same value. Alternatively, Normalized adjustments identify the multiplication factor required to increase or decrease the zonal average to the target value. In short, Normalized adjustments maintain the spatial distribution of the gridded values. Additionally, Zonal Adjustments may be performed on temporally averaged (PER-AVER or INST-VAL) or aggregated (PER-CUM) values. For example, if hourly precipitation data is being viewed, the one-day total may be adjusted, and that adjustment will automatically be disaggregated to the individual hours, based on the Uniform vs Normalized settings. When using Uniform adjustments, the one-day total would be disaggregated by dividing by 24 hours, then applying that value to each hour. Alternatively, when using Normalized disaggregation, the computed scaling factor is applied to each individual hour, maintaining the temporal precipitation pattern. 

Values Shown in the Zonal Adjustment Editor

The editor computes each zonal value as the average of valid TIN points within the zone. For gridded data, the selected points are the grid-cell centers within the zone. This matches the points affected by an edit. These values can differ from the area-based averages used by Basin Average Maps and saved basin-average time series. Undefined values are excluded. Zones with no usable data are omitted from the editor, and a warning identifies them.

For table editing, clipboard operations, and time aggregation, see Using the Zonal Adjustment Editor.

Adjusting a Zone from the Map Window

  1. Load the data and define the required Zones in the Map Window.
  2. Right-click inside a polygon belonging to the zone, then select Ad Hoc Operations > Zone Operations > Adjust Measurement Values for Zone "zone name"....
  3. Choose Add, Multiply or Set, enter the value or factor, and confirm.
  4. Review the result in the Map Window and the Edit Tracking Tool.

This operation applies to the selected zone over the entire loaded time window, rather than only the currently displayed Dynamic Time Window. Use the Zonal Adjustment Editor for adjustments to selected time intervals. Zone Operations is disabled when no TIN is loaded, no zone is defined at the clicked location, or the zone shapefile data is unavailable.