A selector (or mover) dialog is once in which two lists are provided side by side with some "move" buttons in between them. Typically, the list on the left is labeled Available and the list on the right is labeled Selected and you are expected to "move" entries from Available into Selected.. The Selector dialog ("Figure: Reservoirs Selector Dialog") gets its name from its primary purpose—to allow you select one or more items from the list of available items.

Figure: Reservoirs Selector Dialog

To make a selection:

  • Double-click on each item in the Available list that you want to select; this will move the item to the Selected list.

—OR—

  • Click on the item in the Available list, then use the Add button to move the selected item to the Selected list.

NOTE: By holding the Shift or Ctrl keys while clicking on an item, you can highlight more than multiple items to be moved with the Add button.

  • Click OK to accept your selections and close the Reservoir selector dialog. Cancel will close the Selector dialog without saving the changes that may have been made to the Selected list.


To select all the items in the Available list:

  • Use the Add All button. This will move all the items in the Available list to the Selected list
  • Click OK to accept your selections and close the Reservoir selector dialog.


To remove items from the Selected list:

  • Double-click on each item in the Selected list that you want to deselect. This will move the item to the Available list

—OR—

  • Click on the item in the Selected list, then use the Remove button to move the selected item to the Available list.

— OR—

  • Use the Remove All button to move all the items from the Selected List to the Available list.
  • Click OK to accept your changes and close the Reservoir selector dialog.