From the WQ Parameter Set Editor (Figure 6.1), use the navigation bar (refer to Section 2.6.1) to toggle between created WQ parameter sets (e.g., WQparameterSet4 selected in Figure 6.1). For the example in Figure 6.1, there are three WQ parameter sets, and the third set is selected to be viewed or edited. It is important to select the correct WQ parameter set when viewing, editing, copying, or deleting a set. The section below the navigation bar (Figure 6.1) displays the geometry dataset linked to the WQ parameter set (linked when the parameter set is created, as described in Section 6.2). The WQ Constituent Set dropdown list contains all WQ constituent sets created and defined (refer to Chapter 5). The Geometry linkage cannot be modified once the WQ parameter set has been created (see Section 6.2).
The WQ Parameter Set Editor (Figure 6.1) has two menus: the WQ Parameter Set menu and the Schematic menu. Section 6.1.2 describes the WQ Parameter Set menu commands, and Section 6.1.3 describes the Schematic menu commands.